Curt trailer hitch # C11724 for your 1993 Honda Del Sol is rated for 150 pounds tongue weight and 1,500 pounds gross trailer weight. The hitch mounts to the bottom of a steel beam at the center/rear of the vehicle. The beam is located inside of the vehicle rear bumper. It also attaches to the vehicle tow loop.
If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with... view full answer...
The 2-Leaf Slipper Spring w/ Radius End part # SP-177275 cannot be disassembled. It has a 500 lb capacity which will be the lowest we can offer. It should still work fine for a 400 ish lb trailer. view full answer...
The Ducted Atwood AC unit part # AT15028-22 that you referenced is designed to replace AC units like what you have now that is designed for ducted roof styles.
This can be used with a furnace but it will require a separate thermostat wired in to control both as the thermostat that comes with this does not have the capabilities. view full answer...
If you have access to the necessary tools and have basic mechanical skills you should not have any problems installing Roadmaster Tow Bars for the 1996 Honda Del Sol part # 510-1 on your 1996 Honda Del Sol.
I talked with our installer here at etrailer and he advised that it would most likely take around 4 hours for you to install this base plate. view full answer...
The base plate kit, or mounting bracket that will fit your 1994 Honda Del Sol is the Roadmaster Base Plate Kit, part # 508-8 as it is designed specifically for your model vehicle. This is the only base plate kit available from Roadmaster for your vehicle. Part # 508-8 will stick out a little past your front bumper to be able to hook to a tow bar. The 508-8 Base Plate Kit does not have removable draw bars and will be visible on your 1994 Honda Del Sol when it is not being towed.
To complete... view full answer...
Due to the softer bumper on your 1994 Honda Del Sol I would recommend only carrying 2 bikes as a max. For that I would recommend the Thule OutWay Trunk Rack part # TH45JV as it would fit the best.
What makes this rack far superior to the others is the attachment system. It uses only 2 rubber coated straps to attach to the vehicle rather than 6 nylon straps like other racks. This makes installation quick and easy and the protected straps also last longer.
This carrier offers a locking... view full answer...
I will be happy to help you pick out the right parts to flat tow your 1993 Honda Del Sol behind your motor home. But first, you will want to consult the vehicle owners manual to determine if it can be flat towed and if so if there are any special requirements.
Base plate kit # 508-8 is the correct kit for all models of the 1993 Del Sol. You will need to trim the splash guard on the bottom of the vehicle (not visible unless you are down there looking for it) to fit around the base plate... view full answer...
I wasn't able to look up your order number using the supplied email address but the correct wiring harness for your 1995 Honda Del Sol is part # 118336 for Tekonsha or part # 43105 for Hopkins. I called Tekonsha and Hopkins to confirm this. Both of these harnesses are a direct plug and play install that will not require you to cut or splice any wires.
Most of the time, it is just simply a case of not being able to find the connector. Hopkins suggested that you look in the back cargo area... view full answer...
When it comes to installing a trailer wiring harness on a 1994 Honda Civic Hatchback I recommend The Upgraded Circuit Protected Tail Light Converter Hardwire Kit w/ 4-Pole Connector and Circuit Tester # 119178KIT. Your vehicle does not have a plug n play option that is confirmed to fit your vehicle. To keep it from getting damaged during non use you can get The Mounting Bracket # 18144 which will attach to your trailer hitch. The 4 plug connector will then be stowed away underneath the... view full answer...
Found the base plate kit you have for your 1995 Honda Del Soul. It's actually the part # 510-1 which is an XL style Roadmaster base plate kit.
This style of base plate will work with all of Roadmasters tow bars. From the Tracker part # RM-020, to the Stowmaster part # RM-501 or the most popular option the Falcon part # RM-520. view full answer...
Go To Results